ace 100 crankshaft flywheel die

taber hodaka · Post by **taber hodaka** » Sat Jan 11, 2020 11:00 am

What metric die would match the threads on the flywheel side of the crankshaft. ------Thanks Clarence

thrownchain · Post by **thrownchain** » Sat Jan 11, 2020 3:19 pm

You just trying to refresh the thread for the puller? I can get the specs off my puller tomorrow.

taber hodaka · Post by **taber hodaka** » Sat Jan 11, 2020 4:56 pm

No the crank shaft, right side. Thanks ------Clarence

thrownchain · Post by **thrownchain** » Sat Jan 11, 2020 5:27 pm

Flywheel is left, clutch is right.

thrownchain · Post by **thrownchain** » Sat Jan 11, 2020 5:33 pm

Right side is also left hand thread ( backward)

viclioce · Post by **viclioce** » Sat Jan 11, 2020 5:53 pm

According to the fiche it’s an M12. I’m thinking maybe a .8 mm thread? And left handed or counter clockwise tightening.

taber hodaka · Post by **taber hodaka** » Sun Jan 12, 2020 2:22 am

Well when I get old I should be able to make mistakes. The flywheel the flywheel, the Left side crankshaft threads. And you are all correct and I am wrong, the flywheel is on the left side. Thanks folks. And the answer is ? ------------------Clarence

thrownchain · Post by **thrownchain** » Sun Jan 12, 2020 5:34 am

10mmx 1.00

taber hodaka · Post by **taber hodaka** » Mon Jan 13, 2020 5:21 am

dumb question. What die for the early 125 wombat crankshaft, mag side?--------- Clarence

thrownchain · Post by **thrownchain** » Mon Jan 13, 2020 6:39 am

Same part number, so the same die.

swcaudill · Post by **swcaudill** » Mon Jan 13, 2020 8:56 am

Buy a metric thread file. If the threads aren't total destroyed it should work fine. Just use the correct size thread, there are 4 sizes on each end.
Sterling

swcaudill · Post by **swcaudill** » Mon Jan 13, 2020 8:59 am

Looked this up just now.
https://www.acehardware.com/departments ... es/2367530
Good Luck,, sterling

taber hodaka · Post by **taber hodaka** » Tue Jan 14, 2020 5:11 am

Thank you very much! On my way, only 20 minutes away.-----Clarence

thrownchain · Post by **thrownchain** » Tue Jan 14, 2020 10:18 am

Got the job done?

The Hodaka Club Forum

The Hodaka Club Forum

ace 100 crankshaft flywheel die

ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Re: ace 100 crankshaft flywheel die

Who is online