Control shaft O ring

[kc57]

I am working on a bike I recently picked up. When I went to lock it in gear , the control shaft pulled free. And I found most of the pieces behind the primary gear So a shaft rebuild is in order. My question is Where does the O ring go ? Does it fit in the end of the counter shaft ? Thanks K.C.

[Dale]

Yes, it fits just inside the countershaft from the left side (sprocket side). Use a pick to remove the old one and grease the new one before installation.

[kc57]

Thank you Dale. I could not see it yesterday. But today there it was.

[Bruce Young]

KC57 parts will be there Friday, Hodakapartsidaho You will have lots of little clips, springs and etc to play with. don,t loose or misplace these. put them in a safe place. Bruce