Has Anyone Seen This Before

The main Page for the Hodaka Club Discussion Group
Post Reply
shunt
Posts: 29
Joined: Wed Sep 25, 2013 12:16 am
Location: South Australia

Has Anyone Seen This Before

Post by shunt »

I don't know if anyone on the Forum has seen this before or has any ideas to what whoever did it was trying to achieve, the back story is, purchased a 125 motor off a guy that buys a lot of Job Lots (deceased estates and the like) who had picked it up in a Job Lot of approx 40 various bikes and assorted parts.
It is Super Combat Crank Cases, Cast Iron Wombat Barrel (mild porting & transfer ports matched to Crankcases) & Carby Manifold, Super Combat Head, Piston is Non Reed Valve, Internal Rotor on Crank (no Ignition Charging Coils [disappointingly]).
At the front of the Ignition side Crankcase (as pictured), there is a steel tube running from under the base of the Cylinder through to the Transfer Port, tube runs straight thru (no check valve or the like).
My plan when I get around to using the crankcases, at present is to just block the hole up, but thought it would be an interesting one to put out there.

Shane
Attachments
20160611_150504.jpg
20160611_150457.jpg
thrownchain
Posts: 1920
Joined: Sun Jul 21, 2013 8:52 am

Re: Has Anyone Seen This Before

Post by thrownchain »

Can't see a purpose in that, if nothing else it's a major air leak.
User avatar
hodakamax
Posts: 2211
Joined: Thu Aug 28, 2014 9:56 am
Location: Parsons Kansas

Re: Has Anyone Seen This Before

Post by hodakamax »

Like the Dr. sez, I've never seen that before. :o I'll take a couple of weird guesses though. How about a nitrous oxide port or maybe the engine had been converted to some sort of pump, driven by a coarse sandpaper belt off the flywheel--I have no idea!

Maxie
taber hodaka
Posts: 2240
Joined: Mon Jul 29, 2013 6:34 pm

Re: Has Anyone Seen This Before

Post by taber hodaka »

Remember when we were experimenting with the diaphragm pumper carbs and it took a pulse to activate them?? But I do not know why you would have the need for two. I used a line to my expansion chamber and it worked. We used snowmobile carbs and they had external adjustments for low and high speed, just like a chainsaw. -----------Clarence
taber hodaka
Posts: 2240
Joined: Mon Jul 29, 2013 6:34 pm

Re: Has Anyone Seen This Before

Post by taber hodaka »

Also the advantage was it would run in any position including on the side or upside down. ---------Clarence
User avatar
ossa95d
Posts: 385
Joined: Fri Jul 19, 2013 3:06 pm
Location: Manchester Vermont

Re: Has Anyone Seen This Before

Post by ossa95d »

Clarence,
I agree that it might be an impulse connection for a pumper carb. There appears only to be only one which would make sense.
Ivan AKA "Pop"
User avatar
hodakamax
Posts: 2211
Joined: Thu Aug 28, 2014 9:56 am
Location: Parsons Kansas

Re: Has Anyone Seen This Before

Post by hodakamax »

OK, You guys idea sounds more reasonable than mine. :roll: Clarence, did the snowmobile carbs perform well? I never fiddled with them.

Max
Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests