Page 1 of 1
Wombat Carb for Super Rat???
Posted: Wed Apr 07, 2021 12:45 pm
by viclioce
Can you configure a 24mm Wombat pull choke carb to work successfully on a Super Rat? If so, can someone tell me all the changes needed? I have a 24mm Super Rat Carb on my 94. But that’s easier to figure out. Thx!
Victor
Re: Wombat Carb for Super Rat???
Posted: Wed Apr 07, 2021 1:22 pm
by viclioce
Looks like I’m able to ID the minor differences! Same needle jet, same jet needle. Change the slide from 2.5 to 2.0; change the pilot jet from 25 to 30; change the main jet from 140/160 to 220! Should work, right?
Victor
Re: Wombat Carb for Super Rat???
Posted: Fri Apr 09, 2021 5:36 pm
by viclioce
Well, the Wombat carb is too short front to back to work with the air cleaner joint!
I’ll see how the JB Weld holds tomorrow. Hopefully I can use that second carb!
Victor