The Hodaka Club Forum

I am working on a bike I recently picked up. When I went to lock it in gear , the control shaft pulled free. And I found most of the pieces behind the primary gear So a shaft rebuild is in order. My question is Where does the O ring go ? Does it fit in the end of the counter shaft ? Thanks K.C.

Yes, it fits just inside the countershaft from the left side (sprocket side). Use a pick to remove the old one and grease the new one before installation.

Thank you Dale. I could not see it yesterday. But today there it was.

KC57 parts will be there Friday, Hodakapartsidaho You will have lots of little clips, springs and etc to play with. don,t loose or misplace these. put them in a safe place. Bruce