The Hodaka Club Forum

I've looked at photos and tried to sort this out but for clarification can someone tell me how the mud apron fits on my B+ please?
Does the red side go toward the engine or the rear wheel? And where does the clip go?
I have one in reasonable condition but it wasn't on the bike when I got it, just in one of the boxes of goodies. I don't have a clip but in the parts book it looks like just a piece of metal that crimps on something?
thank you!
Ken

The red side goes towards the motor. The clip, I believe, goes on the left front bottom of the fender, but I didn't have a clip. I've been trying to upload a photo but it hasn't been cooperating! ; D Victor

Thanks Victor. That helps a lot. I'll play with it tomorrow night. I searched this forum and google but couldn't find a photo that clearly showed the apron in place.
Ken

For some reason, all of a sudden, when I try to attach a photo, it doesn't want to show up in the preview. Let's see if it shows in the post? ; D Victor
Ahh good it did! Enlarge & zoom in a bit and you can see it now!

Thanks again Victor. Your photo shows it better than others I had found.
Ken

Glad it helps! I could see it pretty good in this pic when I zoomed in on my phone! Victor

This is as picture on the apron as I can get. click on picture to inlarge Ithink.
If this works

Looks good! Is that a new one or did you paint the old one? Victor

new one
MTRob

Rob what is your engine # and frame I am trying to time line some of the changes? Good looking paint, the color as I remember it. Where did you get a new apron?? -------------Clarence

Thanks Rob. Another good photo to go by. Your bike looks fantastic! (I'm embarrassed to put up a pic of mine, )
Ken

Clarence
1963 title says that, Engine # PO262 frame #AO259 Apron Found on Ebay after searching longtime.
MTRob

Rob to me your bike was built about August 23 1964

clarence
Title says 63, checked thr engine # and frame points to 63. real low Engine and frame #, I want you to take a good look at that engine
different looks than other 90's i have looked at. Did I read your going to get to my 125 wombat engine or was that a dream.
MTRob

Rob I will reply on reflecting on the Ace 90.----------Clarence

viclioce

Hodaka 90 ,100 use the same apron you can get it from Hodaka-parts.com part #939515 for $31.46 new
MTRob

My old one is fine for now. Too many other expenses on the 2 Toads yet to replace something just for pretties! Maybe if I take my B+ to a show??? Victor