Looking for Hodaka experience on low end rrassembly for 1st thru 5th gears..... Each gear sprocket has a raised side and flat side....in order, do all gears face raised side to left or right?(top down view). Have reassembled and sealed but gears, kick start gear and crank all tight (should be free rotation).... Washers everythg in place.....what did i do wrong? Have isolated it and definitely gears arrangement of gears or is there a gasket for low end causing it, cant figure this one out...help....
Stewart
73 Combat Wombat Low End Gears
-
Bullfrog
- Posts: 2784
- Joined: Mon Jul 22, 2013 4:05 pm
- Location: Oregon, 12 miles from the center of the Hodaka Universe(Athena)
Re: 73 Combat Wombat Low End Gears
Shoulder toward the ball bearing.
Ed
PS: Would write more but have to get going to the Hodaka Days Parade down main street in Athena.
Ed
PS: Would write more but have to get going to the Hodaka Days Parade down main street in Athena.
Keep the rubber side down!
Re: 73 Combat Wombat Low End Gears
Shoulder to the left. Most are that way but not all models.
Bill Chapman, Monument, CO
Raced and Modified Hodakas in Statesville NC back in the day.
Raced and Modified Hodakas in Statesville NC back in the day.
-
Pre64new64
- Posts: 6
- Joined: Mon Jun 02, 2014 8:53 am
Re: 73 Combat Wombat Low End Gears
Jealous...wish mine was completed...would be there...
P.S....ask around, have 72 Wombat about 75% there in need of home...depends on buyer...great project bike and not gonna get to refurb for a while...traveling again by end of July.. thx for help on both...Parker Co...
Thx
Stewart
P.S....ask around, have 72 Wombat about 75% there in need of home...depends on buyer...great project bike and not gonna get to refurb for a while...traveling again by end of July.. thx for help on both...Parker Co...
Thx
Stewart
Who is online
Users browsing this forum: No registered users and 2 guests