The Hodaka Club Forum

I'm seeking a set of bars for an early Ace 90 I'm beginning. I know I'm unlikely to find originals (that's OK, I'm not a perfectionist), but I'd like to achieve the "low bar" look the earliest 90's had.
Anyone have a rusty/bent original you would sell? Or do you have an original (on or off a bike) you could measure for me to seek a modern, similar bar?
Appreciate any help
Bob

Bob. I have an original set. They are a bit rusty, but can be cleaned up and rechromed, if that’s what you want! They are yours for shipping! Send me a private messsge & I’ll dig them out & send you a pic. Victor

Ives looking for low bars.

Victor those bars are for the last of the three models of the ace 90. The early ones including the Mach // were low bars, the first production ace 90's used part #908740 up until frame number P0231 I know it should have been A0231 but that is what my parts list shows. The ace 90 after frame 0231 used handle bars #908740A. The high handle bar came on ace 90 frame #P6533 according to my parts list {error}?? the part number was 908740C. ----- Clarence

The ace 90 bars, did not have the the cross bar. ------------ Clarence

Bob. I found these on eBay & used them on my 90! Is this more like what you are looking for? Victor

https://www.ebay.com/itm/124402259348

Victor those 6 inch bars would more likely fit the last ace 90's beginng with frame 6563. The early bars were about 4 inches. ------ Clarence

Yes, seeking the bars shown with Kelly astride.

Bob. I buy bars from Emgo like that on eBay for around $40 shipped! Victor

https://www.ebay.com/itm/192970101126

https://www.ebay.com/itm/334004753980?_ ... =209924165