Page 1 of 1
Help identifying pistons
Posted: Sun May 10, 2020 12:06 pm
This piston is 50.00mm
Re: Help identifying pistons
Posted: Sun May 10, 2020 12:35 pm
by matt glascock
I'll give it a go. Single Dykes ring configuration suggests stock racing piston for a toaster tank Super Rat.
Re: Help identifying pistons
Posted: Sun May 10, 2020 6:30 pm
by Bullfrog
Are you measuring at the top of the piston? Check measurement at the bottom of the piston skirt. Piston is stamped 0.010" over-size - should measure very close to 50.25mm at bottom of skirt.
Ed
Re: Help identifying pistons
Posted: Sun May 10, 2020 6:56 pm
I did measure at the top. Thanks for your help