Page 1 of 1
ace 100 crankshaft flywheel die
Posted: Sat Jan 11, 2020 11:00 am
by taber hodaka
What metric die would match the threads on the flywheel side of the crankshaft. ------Thanks Clarence
Re: ace 100 crankshaft flywheel die
Posted: Sat Jan 11, 2020 3:19 pm
by thrownchain
You just trying to refresh the thread for the puller? I can get the specs off my puller tomorrow.
Re: ace 100 crankshaft flywheel die
Posted: Sat Jan 11, 2020 4:56 pm
by taber hodaka
No the crank shaft, right side. Thanks ------Clarence
Re: ace 100 crankshaft flywheel die
Posted: Sat Jan 11, 2020 5:27 pm
by thrownchain
Flywheel is left, clutch is right.
Re: ace 100 crankshaft flywheel die
Posted: Sat Jan 11, 2020 5:33 pm
by thrownchain
Right side is also left hand thread ( backward)
Re: ace 100 crankshaft flywheel die
Posted: Sat Jan 11, 2020 5:53 pm
by viclioce
According to the fiche it’s an M12. I’m thinking maybe a .8 mm thread? And left handed or counter clockwise tightening.
Re: ace 100 crankshaft flywheel die
Posted: Sun Jan 12, 2020 2:22 am
by taber hodaka
Well when I get old I should be able to make mistakes. The flywheel the flywheel, the Left side crankshaft threads. And you are all correct and I am wrong, the flywheel is on the left side. Thanks folks. And the answer is ? ------------------Clarence
Re: ace 100 crankshaft flywheel die
Posted: Sun Jan 12, 2020 5:34 am
by thrownchain
10mmx 1.00
Re: ace 100 crankshaft flywheel die
Posted: Mon Jan 13, 2020 5:21 am
by taber hodaka
dumb question. What die for the early 125 wombat crankshaft, mag side?--------- Clarence
Re: ace 100 crankshaft flywheel die
Posted: Mon Jan 13, 2020 6:39 am
by thrownchain
Same part number, so the same die.
Re: ace 100 crankshaft flywheel die
Posted: Mon Jan 13, 2020 8:56 am
by swcaudill
Buy a metric thread file. If the threads aren't total destroyed it should work fine. Just use the correct size thread, there are 4 sizes on each end.
Sterling
Re: ace 100 crankshaft flywheel die
Posted: Mon Jan 13, 2020 8:59 am
by swcaudill
Re: ace 100 crankshaft flywheel die
Posted: Tue Jan 14, 2020 5:11 am
by taber hodaka
Thank you very much! On my way, only 20 minutes away.-----Clarence
Re: ace 100 crankshaft flywheel die
Posted: Tue Jan 14, 2020 10:18 am
by thrownchain
Got the job done?