The Hodaka Club Forum

Has anyone done this to a 93 rat ? What is involved?

I bought a cylinder to have it bored. The intake ports were nicely done BUT it is in a "V" pattern. I don't think the originals were that way. I may have to convert to reed valve if the cylinder was modified to this. So, if this is true, where do I get the reed valve block etc? I know about the piston.


Thanks for any advice.

The "V" pattern means it was converted to reed valve. You will need the 207020 reed induction kit. I don't see the kit listed on Paul's site but you could call him and ask. They are still available from Hodaka-parts.com.

Brian

Guys I am in the very crucial ending to supplying Ken information for the Hodaka Book. This has to be finished in days so I hate to say it but I am slammed.
I am sure I can help with that part if needed but the part number is wrong for a Super Rat reed valve (207020). This part # is for a two bolt intake not four bolt.
Please give me a week. I have it if needed. Sorry for the delays. Tons of personal emails but right now I (we) have to finish this book.
Thanks
Paul

Somethings amiss. I have the reed induction kit sitting in front of me and the part number on the package is 207020 and it is for a 4 bolt manifold. It states that it fits the Combat cylinder, Wombat cylinder and Super Rat cylinder and is for use with a 28mm - 34mm Mikuni.

Brian

OK sorry if I made a mistake the one I have shows it is for a two bolt intake manifold.Super Rat you are correct is a four bolt intake.
Sorry
Paul

When I reference the Hodaka-parts.com site and call up P/N 207020 it shows a picture of the RV-120 reed valve kit (for 2 bolt manifolds). The picture is incorrect.

Brian

admin wrote:OK sorry if I made a mistake the one I have shows it is for a two bolt intake manifold.Super Rat you are correct is a four bolt intake.
Sorry
Paul

No problems Paul. Maybe you should think about a vacation after your book hits the shelves!

Brian