Page 1 of 1
Looking for a VM20 carb
Posted: Thu Mar 07, 2019 10:49 am
by viclioce
Looking for a VM20 I can rebuild. Anyone out there have one they can part with? I can put jets in it if needed. Just need a basic body & slide that’s functional. I even have floats so those aren’t necessary! Thanks in advance!
Victor
Re: Looking for a VM20 carb
Posted: Fri Mar 08, 2019 3:03 am
by hodakamax
Victor, I have one that's kinda grim if you can't find a nice one. Lotsa crud on this one. Keep me posted. You are welcome to it. Maxie
Re: Looking for a VM20 carb
Posted: Fri Mar 08, 2019 4:19 am
by Tether
Is this what you are looking for?
It was on an Ace 100 motor that I picked up in a parts bunch I recently acquired.
Re: Looking for a VM20 carb
Posted: Fri Mar 08, 2019 4:28 am
by thrownchain
That's not it, Hodaka used a flange mount carb, that's a spigot mount.
Re: Looking for a VM20 carb
Posted: Fri Mar 08, 2019 5:01 am
by Tether
Interesting, it appears that it is a Dirt Squirt 80 carb on the 100 motor No. P-19423
Re: Looking for a VM20 carb
Posted: Fri Mar 08, 2019 5:44 am
by bobwhitman
Bob
Could you email me good pix of that carb and measure both (in/out) diameters? I just acquired a similar looking carb which I believe is marked xx17xx (I’m not home now so can’t confirm the markings). Mine is definitely smaller than a 20mm & is a slip fit.
Bob
Re: Looking for a VM20 carb
Posted: Fri Mar 08, 2019 7:05 am
by Tether
Bob, I sent you an email
Re: Looking for a VM20 carb
Posted: Fri Mar 08, 2019 7:29 am
by viclioce
Maxie! You have a PM!!!
Victor