Page 1 of 1
Model 94 head stay
Posted: Sun Nov 17, 2013 11:19 am
by michael_perrett
I am thinking of installing a model 94 head stay on my model 95 CW. After digging down to about 5 feet, depth wise, into my parts bin, I found the brackets, including the rubber bushing set up. I am still looking for the two special head nuts and the frame clamps. Were not the frame clamps, just handlebar clamps?
Meditating always in the Research and Meditation Center.
Mike Perrett
Re: Model 94 head stay
Posted: Sun Nov 17, 2013 4:26 pm
by Bullfrog
I believe you have that right, oh Meditation Master.
Ed
Re: Model 94 head stay
Posted: Tue Nov 19, 2013 4:17 am
by RichardMott
Mike,
I have the whole kit and kabudol. I will bring it to York. I was going to install it on my CW, but have changed my mind.
Rick Mott
Re: Model 94 head stay
Posted: Tue Nov 19, 2013 4:51 am
by admin
Meditation Master your piston should arrive today ohhh mighty one
Re: Model 94 head stay
Posted: Tue Nov 19, 2013 1:37 pm
by michael_perrett
Rick, I only need the two cylinder head bolts to complete this addition. Could you send them up? I hate to wait until January.
Mike
Re: Model 94 head stay
Posted: Tue Nov 19, 2013 1:38 pm
by michael_perrett
Thanks Paul. I can finally get my spare 175 engine together.
Mike
Re: Model 94 head stay
Posted: Tue Nov 19, 2013 2:34 pm
by RichardMott
Mike,
I am in Brazil until November 27. I have something else to send you anyway for Christmas. I will send everything out as soon as I get back.
Rick
Re: Model 94 head stay
Posted: Sun Dec 15, 2013 3:33 pm
by RichardMott
Mike
I will send the head bolts Monday, 12/16. Just got back in town.
Rick