Page 1 of 1
100B+ Rear Fender Dimension Needed
Posted: Thu Jun 07, 2018 2:49 pm
by danshale
Got incorrect fender shipped and away from bike- some have 100B+ can confirm dimension on pN-
928630A - Fender rear from front bottom to mounting holes at rear of frame loop?
Thx
Re: 100B+ Rear Fender Dimension Needed
Posted: Thu Jun 07, 2018 11:51 pm
by taber hodaka
Dan what is the engine number on that or frame # ------------ Clarence?
Re: 100B+ Rear Fender Dimension Needed
Posted: Fri Jun 08, 2018 3:39 am
by danshale
Not at bike- made Feb-1972, think pic says A-68959
Re: 100B+ Rear Fender Dimension Needed
Posted: Mon Jun 11, 2018 11:07 am
by RylanCoffey
Beautiful bike !!
Re: 100B+ Rear Fender Dimension Needed
Posted: Mon Jun 11, 2018 3:04 pm
by dirty_rat
The dimension that I got are as follows:
From the front edge of the fender to the rear mounting holes - 22 1/4"
From the front mounting holes to the rear mounting holes - 20 3/4"
Those dimensions were taken using a tape measure so they could be off just a little.
Hope that helps.
Re: 100B+ Rear Fender Dimension Needed
Posted: Wed Jun 13, 2018 5:36 pm
by danshale
Thx very much for this, sent info to someone who comfirming a match. This was a big help.