Page 1 of 1

Hello All: New to Forum & Hodaka

Posted: Wed Apr 04, 2018 6:10 am
by GutterRat
Hello Forum. I'm new to Hodaka and found a solid project, minus a few things (tank). LOL. Anyway. Here's my questions. First off, I need to know what I have. My frame number is E06119. I'm thinking that its a Dirt Squirt yet, not 100% if Model 92 or Model 96. Any help or guidance would be appreciated. Also, which is the best manual to use once I take on this restoration? Thank you for the help - Jack

Re: Hello All: New to Forum & Hodaka

Posted: Wed Apr 04, 2018 7:18 am
by olddogs
Great find. That's a chrome tank Dirt Squirt. Same tank as the Combat Wombat, so finding that that might be your biggest challenge. Rest of the parts are very common with other bikes in the family. The chrome tank squirt with the red frame was one of Hodakas best looking bikes. Enjoy building and riding it. Lots of help available here.

Re: Hello All: New to Forum & Hodaka

Posted: Wed Apr 04, 2018 8:00 am
by bobwhitman
Models 92 & 96 are essentially the same.

Re: Hello All: New to Forum & Hodaka

Posted: Wed Apr 04, 2018 8:16 am
by byarwin
Be careful GutterRat these bikes will get into your blood and you'll be hooked. Soon your garage will be filled with them...

Re: Hello All: New to Forum & Hodaka

Posted: Wed Apr 04, 2018 8:31 am
by JackM
Very true. This time last year I had one. Now I have three.

Re: Hello All: New to Forum & Hodaka

Posted: Wed Apr 04, 2018 9:11 am
by gearyoliver
Welcome from another new forum member. You're in for a lot of fun.

Re: Hello All: New to Forum & Hodaka

Posted: Wed Apr 04, 2018 10:10 am
by Dale
bobwhitman wrote:Models 92 & 96 are essentially the same.
I think this should say 92C and 96 are essentially the same.

Re: Hello All: New to Forum & Hodaka

Posted: Wed Apr 04, 2018 12:10 pm
by go_hercules
Hey GutterRat, here is my 1973 Dirt Squirt. I never quite figured out myself what the deal is with model 96 or 92C. I don't know why it just wasn't one or the other. Oh well....

Re: Hello All: New to Forum & Hodaka

Posted: Thu Apr 05, 2018 1:24 am
by GutterRat
Thank you all for the welcome. Its much appreciated it. Yes, I was looking around I researched it and theres something about the looks of the Hodakas........and I agree, I have a feeling that there will be more than one by the end of the summer. LOL. I'm looking forward to getting started on it. Thats for sure. However, what is the best service manual for the Dirt Squirt, and other Hodakas? Have a great day.

Re: Hello All: New to Forum & Hodaka

Posted: Thu Apr 05, 2018 3:18 am
by Dale
GutterRat wrote:Thank you all for the welcome. Its much appreciated it. Yes, I was looking around I researched it and theres something about the looks of the Hodakas........and I agree, I have a feeling that there will be more than one by the end of the summer. LOL. I'm looking forward to getting started on it. Thats for sure. However, what is the best service manual for the Dirt Squirt, and other Hodakas? Have a great day.
Shop manuals were not created for all models, but the Wombat, Combat Wombat manual will serve you well for your Dirt Squirt as well as others. Here is one place to obtain one.
https://www.strictlyhodaka.com/Workshop ... 209004.htm

Re: Hello All: New to Forum & Hodaka

Posted: Thu Apr 05, 2018 5:07 am
by GutterRat
Thank you for the link and advice. I'm going to check in on that. There are some parts missing. Won't know until I break her down. LOL

Re: Hello All: New to Forum & Hodaka

Posted: Thu Apr 05, 2018 6:33 am
by dirty_rat
As already mentioned, the Wombat / Combat Wombat workshop manual will be helpful, especially on the frame, etc. The Dirt Squirt frame is the same as a Wombat frame except the swingarm is a little shorter and the Dirt Squirt used 19" front and 17" rear wheels (Wombat used 21" front and 18" rear wheel). The engines are very similar except for the top end (cylinder, piston, head, crankshaft carb and pipe). The Dirt Squirt engine is more like an Ace 100 engine, so you might want to get a shop manual for the Ace 100 / Super Rat as well as the specifications for the engine will be correct for your engine.

Re: Hello All: New to Forum & Hodaka

Posted: Fri Apr 06, 2018 2:14 am
by GutterRat
Sounds good. Looks like I'm going to be looking for 2 manuals. LOL I appreciate the guidance

Re: Hello All: New to Forum & Hodaka

Posted: Fri Apr 06, 2018 4:30 am
by Dale
Either shop manual will serve you fine and then refer to the specifications listing for your specific model. The specs can be found online at either Strictly Hodaka or Hodaka-Parts.

Re: Hello All: New to Forum & Hodaka

Posted: Mon Apr 09, 2018 2:30 am
by GutterRat
After looking at my Dirt Squirt. The top end was loose, so I took it off and guess what I found.......well, what I DIDN'T FIND. No piston. So now I'll need to look for a piston, however, the cylinder will need to be honed or bored. The gift that keeps on giving. At least I have a couple other projects ahead of this one. LOL. Oh well........Mr. Murphy is ALWAYS hanging around me. LOL

Re: Hello All: New to Forum & Hodaka

Posted: Tue Apr 10, 2018 3:23 am
by socalhodaka
Jack, let us know where you are from. There’s a good chance another Hodaka nut is near by. Post a photo of your project also, we like to see what your working with and last join the Hodaka club b

Re: Hello All: New to Forum & Hodaka

Posted: Tue Apr 10, 2018 1:26 pm
by Makotosun
Welcome to the asylum! These bikes will multiply in your garage seemingly all by themselves. I started with 1 about 5 years ago,now we have 6 in various stages of finish!

Re: Hello All: New to Forum & Hodaka

Posted: Tue Apr 10, 2018 2:45 pm
by GutterRat
Thank you all. I'm from SWMO. The Hodaka caught my eye and I had to grab this Squirt. Its lived a rough life, so hopefully I can resurrect it and save it. LOL. Missing some things.

Re: Hello All: New to Forum & Hodaka

Posted: Tue Apr 10, 2018 3:20 pm
by socalhodaka
Easy, worst have been saved. Nice Webco Head it looks like on there.

Re: Hello All: New to Forum & Hodaka

Posted: Wed Apr 11, 2018 1:23 am
by GutterRat
I'm very novice to the MX world. All I've ever owned and operated have been Utility ATVs. LOL. I'm probably going to begin disassembly this weekend on this once I get my manual ordered. I don't know much about Webco. I'm looking at this bike as a parade and vintage racing bike. As most of you have said, they multiply in a garage. Well, I'm thinking that is what is about to happen. LOL. I'm just glad the wife has me on a budget......At least that'll keep me out of the dog house. Might still be in the pen.....but not the doghouse. LOL