The Hodaka Club Forum

Hey All, I am finally to the end of my Super Rat (98) project with the last thing that needs to be addressed are the dings in my pipe. Does anyone know someone who does this and who is reputable? The expansion chamber has no major dings, just a few small ones.

I have seen ads for a company that does repairs on expansion chambers. I don't know anything about them, but you might give them a call. Here is their information: Pacific Crest Pipe Repair, 541-664-0400, www.piperepair.com

Check out the "Recommended Tech Specialists" on the FAQ tab on Strictly Hodaka. I've had a Torque Engineering low pipe converted to a high right-side mount for my Super Rat with additional welds and ding work by Hodaka Dave Rozier and the work was absolutely first rate. I've also seen the work of George Cone. Ditto on the quality. There is also a great series of pipe repair work videos by Kelly McKeirnan of SoCal Hodaka that is excellent. You can't go wrong with any of these guys.

Thanks Guys, I will check into this.