The Hodaka Club Forum

I looked up the intake manifold for a Model 95 but there wasn't much of a description. No size information especially. Here's the part number:

41-Item# /Fig.F -Hodaka Part#_953504 - Inlet manifold

Is this the standard 28mm intake in size? Just need to confirm it. Thanks! ; D Victor

The carb is 28mm flange mount so I would assume the manifiold is 28mm where it mates to the carb. However, this part number only shows up for the model 95.

Yes, the "95" intake manifold is Combat Wombat specific and is appropriate for the flange mount 28mm Mikuni which was stock on the CW.

Ed

OK Thanks! ; D Victor