Page 1 of 1
+crank case breather
Posted: Fri Jun 05, 2015 7:02 am
by Dennis Bannert
How do I remove the breather on the top of the crankcase for my 1973 125 Hodaka 94A?
Re: +crank case breather
Posted: Fri Jun 05, 2015 7:04 am
by Dennis Bannert
Does the breather vent on my 1973 Hodaka 125 94A screw out?
Re: +crank case breather
Posted: Fri Jun 05, 2015 7:12 am
by Pep
No threads. Can be a bit of pain to remove. There's a good thread on this forum about breather mods...
Re: +crank case breather
Posted: Fri Jun 05, 2015 9:33 am
by MTRob
Dennis I have a 73 124 Wombat 94A also. Why do you want to remove the breather?
MTRob
Re: +crank case breather
Posted: Fri Jun 05, 2015 7:07 pm
by Zyx
Never tried to figure it out but I think they are pressed in place, possibly deformed slightly like a rivet. I have heard of folks drilling them out, but that's about the only way I know of. Unless you provide an alternate vent, I would leave it be because it needs something. If you use the oil dip stick as a screw in vent location, the original vent is redundant.
Re: +crank case breather
Posted: Sat Jun 06, 2015 12:02 am
by dcooke007
Heat the aluminum case and using a twisting motion remove carefully with a pair of vise grips. Performed carefully it will not mar the vent. Of course depends on how tight it is too.
Danny
Re: +crank case breather
Posted: Sat Jun 06, 2015 3:59 am
by taber hodaka
Some oils do foam and when they do it is a problem. When using non foaming oils it has never been a problem. The majority of Hodaka's have never had a problem with foaming overfilling yes. ----------Clarence.