Main Shaft C Ring Tool???

[thrownchain]

Bruce, shoot me a mailing address. Anyone else need any? Do the same.

[Bruce Young]

Dan, Bruce Young 2995 Lower Bluff Rd., Emmett, Idaho 83617 Thanks

[taber hodaka]

Dan I could use two also. Clarence Taber -------24 Taber Lane ------- Columbia Falls Montana ------- 59912

[viclioce]

Update!

Talked to Terry. He thanked me for starting up the talk about these!

He told me Danny is too busy with his new job to make them now, so he’s speaking with a near by machinist about making some up for him.

He laughed and said, “There’s never any interest in this tool until we start talking about it on the forum.”

So let’s get a good order up to make it worth Terry’s efforts! I’ll take the older style!!! Victor

[thrownchain]

Will the cost be the same? If I could get one to copy I have a friend who could make me up one.

[gregg_floren]

I would take one of each size.

Gregg

[viclioce]

I hope Terry is monitoring..... Victor

[thrownchain]

Bruce, Clarence, the pins are in the mail.

[Bruce Young]

Thanks, Dan, received the pins today, will put check in the mail. See you at Hodaka Days 2019, stay safe Bruce Young

[djdesantis]

Count me in, for the early one. Thanks

[hodakapartsinc]

I reached out to Danny Cooke on these tools and he has decided at this time he will NOT be able to produce any due to his job and workload he has. After speaking with him I contacted a local machine shop that HPI, Paul, and Hodaka Dave has used in the past. I dropped of samples of both styles and he is looking into the amount of work it will take to make this tool on a small production run. Again, as we have stressed before, be patient. If he can make a run of these, we will pst the info on here and our website.