Kick stand holder

[viclioce]

It looks like someone cut the kick stand holder off the Wombat I just bought. Does anyone have this piece lying loose around there shop or have a bad frame with one which could be cut off?

This is the piece I mean. And it was cut off about where I drew the yellow line.

If you have one you can spare, please let me know! Thanks in advance! Victor

[thrownchain]

I may have one.

[viclioce]

That would be absolutely great! I await your confirmation!!! Victor

[thrownchain]

I have 2, both on scrap frames

[viclioce]

Whatever you can send me. I need at least one. I’d also like to put one on my SC frame. I’ll PM you my mailing address! Victor

[viclioce]

Thrown. You have a PM!!! Victor

[viclioce]

Thrown. I sent you a second PM. Please read it & reply! Thanks! Victor

[viclioce]

Thank you Dan! PayPal sent! Merry Christmas!!! Victor

[thrownchain]

Theyll go out Monday.

[viclioce]

Thank you Sir! Merry Christmas!!!
I went and looked at the Ace 90 I just bought & it’s missing the kickstand mount also. So sending me 2 was a great idea! Thanks again! Victor

[[email protected]]

VIC,
I would just make one from a piece of "Angle Iron".
Just drill a hole, cut and file it, then you could even Heat Treat it.

[viclioce]

Rick, Not a bad idea, if I can find thick enough angle iron. But Dan is sending me a couple from some cut up frames he has! Victor

[viclioce]

Well, knowing that I had a need, and knowing I wasn’t the only one who likely needed kick stand mounts to weld onto frames, I arranged to have one copied and had 10 new ones made!

They are all ready to weld onto your frame! I’ve had 10 made, Snd will make more as needed. I’ve already sold 2! If you need a kick stand mount contact me via private message or by email! Victor