The main Page for the Hodaka Club Discussion Group
viclioce
Posts: 4848 Joined: Mon Apr 21, 2014 5:35 pmLocation: Santa Fe, NM
Contact:
Post
by viclioce Thu Aug 16, 2018 12:36 pm
Remember when I told you guys I use some Bar Keepers Friend for cleaning chrome & stainless steel?
Here’s before & after photos of my exhaust shield. Cleaned it first with the Bar Keepers & then some aluminum foil & Water after the Bar Keepers.
Though there are some scratches in the middle diwn to below the chrome, I think it looks much better after the cleaning. Time elapsed was about 10-15 minutes.
Make sure to enlarge to really see the differences!
Victor
Attachments
Before
After
Last edited by
viclioce on Sun Aug 19, 2018 3:58 pm, edited 1 time in total.
givergas
Posts: 790 Joined: Sat Sep 16, 2017 11:41 amLocation: minnesota
Post
by givergas Thu Aug 16, 2018 12:48 pm
Do you use water with the bar keepers or scrub with it dry
viclioce
Posts: 4848 Joined: Mon Apr 21, 2014 5:35 pmLocation: Santa Fe, NM
Contact:
Post
by viclioce Thu Aug 16, 2018 1:09 pm
I used warm water and an old terry cloth wash rag, from the wife’s rag bag!
Victor
hodakamax
Posts: 2211 Joined: Thu Aug 28, 2014 9:56 amLocation: Parsons Kansas
Post
by hodakamax Thu Aug 16, 2018 1:23 pm
Good job Victor!
Last edited by
hodakamax on Thu Aug 16, 2018 1:23 pm, edited 1 time in total.
TheBevman
Posts: 172 Joined: Fri Sep 06, 2013 5:04 am
Post
by TheBevman Fri Aug 17, 2018 4:23 am
Gonna have to try that, thanks for sharing.
'72 Wombat (94)
viclioce
Posts: 4848 Joined: Mon Apr 21, 2014 5:35 pmLocation: Santa Fe, NM
Contact:
Post
by viclioce Fri Aug 17, 2018 5:58 pm
You’re welcome!
Victor
viclioce
Posts: 4848 Joined: Mon Apr 21, 2014 5:35 pmLocation: Santa Fe, NM
Contact:
Post
by viclioce Sun Aug 19, 2018 4:01 pm
I’m assuming those curved scratches are kick lever related? I can’t imagine anything else doing that. Going to try and clean it out a bit with the brass wire brush wheel on my drill.
Victor
Users browsing this forum: No registered users and 0 guests
Victor