Part ID Confirmation

The main Page for the Hodaka Club Discussion Group
Post Reply
viclioce
Posts: 4848
Joined: Mon Apr 21, 2014 5:35 pm
Location: Santa Fe, NM
Contact:
Contact viclioce

Part ID Confirmation

Post by viclioce »

I looked up the intake manifold for a Model 95 but there wasn't much of a description. No size information especially. Here's the part number:

41-Item# /Fig.F -Hodaka Part#_953504 - Inlet manifold

Is this the standard 28mm intake in size? Just need to confirm it. Thanks! ; D Victor

1978 175SL
1976 03 Wombat
1975 99 Road Toad (2)
1973 96 Dirt Squirt (2)
1973 “Wombat Combat”
1973 Combat Wombat
1972 94 Wombat (2)
1972 Super Squirt
1971 92B+ Ace
1970 92B Ace 100B (2)
1968 92 Ace 100
1966 Ace 90
; D Victor
Top
User avatar
bchappy
Posts: 448
Joined: Fri Jul 19, 2013 6:46 am
Location: Monument, CO

Re: Part ID Confirmation

Post by bchappy »

The carb is 28mm flange mount so I would assume the manifiold is 28mm where it mates to the carb. However, this part number only shows up for the model 95.
Bill Chapman, Monument, CO
Raced and Modified Hodakas in Statesville NC back in the day.
Top
User avatar
Bullfrog
Posts: 2784
Joined: Mon Jul 22, 2013 4:05 pm
Location: Oregon, 12 miles from the center of the Hodaka Universe(Athena)

Re: Part ID Confirmation

Post by Bullfrog »

Yes, the "95" intake manifold is Combat Wombat specific and is appropriate for the flange mount 28mm Mikuni which was stock on the CW.

Ed
Keep the rubber side down!
Top
viclioce
Posts: 4848
Joined: Mon Apr 21, 2014 5:35 pm
Location: Santa Fe, NM
Contact:
Contact viclioce

Re: Part ID Confirmation

Post by viclioce »

OK Thanks! ; D Victor

1978 175SL
1976 03 Wombat
1975 99 Road Toad (2)
1973 96 Dirt Squirt (2)
1973 “Wombat Combat”
1973 Combat Wombat
1972 94 Wombat (2)
1972 Super Squirt
1971 92B+ Ace
1970 92B Ace 100B (2)
1968 92 Ace 100
1966 Ace 90
; D Victor
Top
Post Reply

Return to “HODAKA CHAT GROUP”

Who is online

Users browsing this forum: No registered users and 5 guests