Torque spec for Road Toad countershaft sprocket

The main Page for the Hodaka Club Discussion Group
Post Reply
Steve C
Posts: 19
Joined: Sat Feb 28, 2015 6:30 pm

Torque spec for Road Toad countershaft sprocket

Post by Steve C »

I'm doing a (very)long term restoration project on a model 99 Road Toad. My manual doesn't list the torque setting for the counter shaft sprocket nut.
Can one of the knowledgeable members of this forum provide me with at least a ball park figure in the inch-pound format? Thanks in advance.
Charlie R
Posts: 131
Joined: Wed Feb 04, 2015 9:32 am

Re: Torque spec for Road Toad countershaft sprocket

Post by Charlie R »

Steve,

This is just a guess but I would think 150-170 in/pounds would be plenty. My less than scientific approach is to tighten to "real snug" then lock with the locking washer.

Charlie R.
Charlie R.
Broken Arrow, OK
Steve C
Posts: 19
Joined: Sat Feb 28, 2015 6:30 pm

Re: Torque spec for Road Toad countershaft sprocket

Post by Steve C »

Thank you for the quick response Charlie. I'll set it in between your two variables.
Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests