Stalled on my b+ problem. Only because it's time to spend money. My 68 has been tough to get into neutral and also sometimes when I shift into 1st it wants to go gack gack between 1st and 2nd like it can't find them. Once I'm in 1st it's fine. Do you you think this is a shifter alignment problem or ...

It actually has a none original light. The harness is
Brand new repro. Was labeled as Ace 100 when I bought it years ago.

Sorry, guys. Ace 100 b+ I was away for a bit. Thanks for the suggestions.

Hello and Happy New year. I'm back at my project. Slow and steady. Had to borrow a torque wrench for my clutch side. I should of taken a pic it was a laughingly large 1/2 inch drive. The click was so inaudible I missed it the first time. Anyways I mounted the bottom end to start on wiring and mounti...

I think I have one

thanks fellers. Looks like I gotta do some shopping. I didn't feel right about it. Thanks for the clarification!!

I believe I bought this from Paul, but not sure. Spec says 15 this is 16 as stated.

Fair enough throw chain. I'm curious about the counter shaft sprocket though. I have a bunch of random ones and this fits but a little sloppy left and right, but not much.

So my maingear has a chip. Pictured. Should I replace or just use it? Also manual stated a 15t counter sprocket. Mine is 16t and a bit loose side to side. Pictured. Thoughts.

FYI Matt, keep an eye on the mail. On the way back with some levers.

Thanks Ed,
Local store didn't have one. Ended up cutting an old outer case screw down...thanks!

So go my cases together. Must of counted wrong and was missing a J screw. Already have it sealed up. Want to run to the hardware store. Anyone now the size pitch of this screw?
ACE100 engine

Got the tool from Matt today. Got that little bugger on. Going to start reassembly. Will probably have some questions along the way. Thanks all!

Awesome, where are you located? Cross my heart!

@mark glascock yes that's what I need. Unfortunately budget does not allow it right now. I was so excited to get my manual. Then the first thing putting the engine back together was this procedure!!! Ha. Thanks bullfrog, and yes Ed tried again with a mechanic friend sweat pouring from us, gave up at...

I'm in Ohio, Columbus. Probably get ahold of Roger Lippiat. Dealt with him a few times and always a pleasure.

Thanks, I found the excerpt in the manual. Unfortunately with an hour on and off with my buddy trying to get the clip on, I surrendered. Just can't afford the tool right now. Hoping I can send the part to someone on here who has the tool. Any takers?

I'm finally getting back to this rebuild after a long hiatus. I bought a control shaft spring kit a long time ago. So I'm not sure if it's "space age". I can tell you the pack is labeled left and right spring. Three clips, two washers the top and the ball receiver. I read and old post abou...

Has the tool always been around? What did people do before it was made? If it was made later.

My files are pretty old. I'm going to work on it some more, but this tank might be a wAsh [/URL]

I've got a pretty old world attitude towards crafts. I repair and make vintage switchblades as a hobby. I filed it for awhile yesterday to no avail. I will try some more. I figured as much about shortening the spout. Wondered if anyone else has tried. Thanks all!

So I've been trying to file these threads might be too marred. Before I concern myself with tank liners... Thoughts on grinding down the top, past the threads til I get to some fresh threads? Thoughts...

?? Thanks

Thanks, I've used evaporust years ago restoring an 80's bmx bike. I do remember it working pretty well. Thanks!!! Going to put some time in tomorrow on the bike. Rain though so might have to wait on pics.